Truck Utilities :: Snow Removal :: Sanders :: Hiniker Salt & Sand Spreaders

Hiniker Salt & Sand Spreaders

Hiniker Salt & Sand Spreaders

Hiniker Salt & Sand Spreaders

Hiniker Salt & Sand Spreaders

Spread ice control materials quickly and easily with an efficient Hiniker Spreader. Snow removal contractors looking for additional profits will find them in ice control. Private users and municipalities will benefit from the labor saving efficiency of the wide 25 ft. spread pattern. And a big 1.50 or 1.80 yard capacity means you'll spend your time productively, rather than constantly reloading.

  • Available in 6.5' & 8' hopper lengths
  • Corrosion-resistant stainless steel construction
  • New swing-away spinner chute for easier unloading and improved trailer hitch access
  • In-cab electric control of starter, throttle, and clutch functions
  • Briggs & Stratton Intek AVS OHV engine
  • Optional easy-access hinged hopper grids
  • Spread salt, sand, or chips quickly and easily with a Hiniker high-capacity 1.5 or 1.8 yard V-box spreader

HOPPER: Formed and welded with continuous electric seam welding on the inside of hopper. The top edge is formed for rigidity. Side slope of 45 degrees allows smooth material flow. An adjustable self-locking feed gate with lever is standard.

GEAR CASE: The conveyor gear case has a
cast-iron housing. A precision-machined, hardened and ground steel worm gear drives a heavy-duty bronze spur gear. Both gears and bearing run in oil and are sealed from contaminants.

SPINNER: 14-gauge spinner chute assembly with
three external adjustable material deflectors provided to control spread pattern. Spinner disc is 12-inch
diameter with three welded fins. Spinner shaft of
3/4" diameter steel is mounted with sealed,
self-aligning bearing.

CONVEYOR: Heavy-duty, self-cleaning, heat-treated pintle chain with 24,000 lb. tensile strength. Two screw-type adjusters are provided to take up chain slack.

CONVEYOR DRIVE: Briggs & Stratton Intek OHV air-cooled, single cylinder, four-cycle engine is mounted on the rear of the spreader. The engine is equipped with an air cleaner, 12V battery, 12V electric starter, and electric throttle control. An in-cab control panel has engine start, shut-off, throttle, and clutch control functions. A hinged engine hood fully encloses the engine. An electric clutch engages and disengages the drive sprocket. Power is transferred to the gear case through roller chain and sprockets.

OPTIONAL EQUIPMENT: 

  • 2 Piece Hinged Hopper Screens 
  • Adjustable Inverted “V” 
  • Ratchet Strap Tie Downs 
  • High-mount Brake Light 

HINIKER SPREADERS SPECIFICATIONS:

                  CAPACITY            LENGTH                           TOP WIDTH
Model 825   1.80 Cubic Yards   115" Overall/96" Hopper    50.5"
Model 625   1.50 Cubic Yards   97" Overall/78" Hopper      50.5"